Ħsara Raġuni Ta ' Ġebla Qtugħ Saw Xfafar

Il- srieraq xafra is an important part of the stone cutting machine, li has a great influence on the effect and efficiency of mechanical production, and is also a relatively easy to damage part. So what are the causes of saw blade damage? Many customers are not very clear about this, so I will explain it to you in detail today.
 
1. Il Segmenti jilbes wisq veloċi
Reasons: The binder of the segments is is too soft (for the material to be cut), insuffiċjenti tkessiħ ilma, loose transmission belt or low voltage or improper speed, resulting in inbiżżejjed power, and the saw blade is not perpendikular to the material to be cut.
Solution: Select a saw blade with a hard binder according to the material to be cut, check the cooling water system, ensure the normal operation of the water pump, ensure sure the power supply voltage, check the maspindle flange, ensure the verticality of the saw blade and equipment, and check the speed.

2. Is-segmenti is mitlufa
Reason: Matul the cutting process, the material to be cut slides and the segments is twisted off, causing the cutter head to be hit hard. The flange plate is worn and cannot fix the saw blade, causing the saw blade to deform. The impact force is large, Overheat force is large, overheating, and the saw blade is violently impacted.
Solution: firmly fix the material to be cut when cutting, replace the flanges on both sides, replace the worn maorn magħżel, check the cooling water, and avoid hitting the saw blade when moveing the equipment or the material to be cut.
 
3. Blunt, unable to cut
Reason: The saw blade bond is too hard, the power is not enough to make the saw blade cut normalment, the saw blade does apply enough cutting pressure, and the saw blade line speed is too high.
Solution: Choose a saw blade with a softer binding force, check the transmission belt, voltage and motor, make sure that enough and not too much cutting pressure is used, and select the corresponding saw blade according to the equipment manual.